Our Products / Self-Contained Emergency Lighting / CU Series
Self-Contained Emergency Light Luminaires
The Self-Contained Emergency Light Luminaires CU Series uses two 12V SMD LED lamps for lighting. The device is controlled by the microcontroller. Thus, it can be tested by remote testing. The front panel is made from ABS UL94 V-0 plastic which has high heat resistance, impact toughness, fracture toughness and corrosion resistance. The rear panel which is used for mounting and housing battery is made from 1.0 mm thick Electro-Galvanized steel sheet and finished with epoxy powder coating and stove enamel which can effectively prevent rust.
Mode of Operation
220 VAC / 50Hz ± 10%
LED Lamp Power
9W / 12W Per Bulb (2 options)
6,000k ± 250k
3,000k ± 250k
Rated Beam Angle
Sealed Lead-Acid Maintained Free
• AC,DC Fuse.
• Battery Low Voltage Cut-Off
• Surge Protection
• Automatic Testing
• Manual Testing or Remote Testing
Constant Voltage & Limit Current
0.1C / Cell
3.0 / 4.0 / 6.0 Hrs. (3 options)
Plastic ABS UL94 V-0 and
Electro-galvanized steel sheet 1mm. thick
250 x 80 x 230 mm.
User Manual & Demonstration VDO
Indicating input status
Indicating charging status
Indicates ready for use status.
LED 5 sec
Indicating that the 5 seconds test is enable
LED 30 mins
Indicating that the 30 minutes test is enable
LED 60 mins
Indicating that the 60 minutes test is enable
Press to turn on/off the device.
Infrared signal receiver from
the infrared remote.